System and Method

MICRODOSING SYSTEM AND METHOD

BRAZIER MDI-P™️ and Sól Mill Dispenser™ are used to dispense and administer measured units of medicaments.

A 1/8 teaspoon of ground flower is equivalent to .63mL of ground flower. If the ground flower strain you used contains 10% THC and 5% CBD, then your 1/8 teaspoon dose was 7mg of THC and 3.5mg of CBD

Use the flameless coil igniter to ignite medicaments void of HPHC’s.

MILL AND DISPENSE

Step 1. Add ½ teaspoon of medicaments between the top and bottom mill plates.

Step 2. Mill by twisting top mill plate several times clockwise.

Step 3. To expose the dispenser chamber, turn the bottom mill plate counterclockwise until it is removed.

FILTER

Step 1. Remove the crown.

Step 2. Disconnect the administering bowl and mouthpiece.

Step 3. Insert the mesh screen into administering bowl.

Step 4. Insert two unbleached cotton filters into the mouthpiece.Step 5. Reconnect mouthpiece to the administering bowl.

DOSE

Step 1. Insert inhaler-pipette into dispensing chamber and twist clockwise to fill the administering bowl with medicaments.

Step 2. Continue twisting the inhaler-pipette clockwise until you feel it reach the bottom of the dispensing chamber.

SUSTAINABLY IGNITE VOID OF HPHCS

Step 1. Blow on the spiral of flameless coil igniter and it will ignite for 7 seconds.

Step 2. Use to ignite medicaments within the bowl of the inhaler-pipette, void of chemicals from lighter fluid or sulfur from matches.

Connect the micro-USB charging cable to a 5 Volt USB output (e.g., laptop/ tablet USB port). USB charges in 20 minutes. The red indicator light shuts off when charging completes.

** DO NOT LEAVE UNATTENDED WHILE CHARGING ** **DO NOT ATTEMPT TO OPEN/ DO NOT OVERCHARGE**

WARNING: The ignitor is an electric device and is NOT waterproof or water-resistant. Therefore, do not wet or submerge the ignitor device in water. Not covered by warranty:

1. Product failure due to improper use, misuse, drops, abuse, alteration, faulty installation, powerline surge or modification.

2. Product failure due to acts of nature such as but not limited to such as a natural disaster, fire, flood, or casualty.

3. Any damage caused to the charging port by user error is not covered by the manufacturer warranty.

SANITIZE AND REPEAT

Step 1. Gently clean out the inhaler-pipette bowl using the teaser needle as shown.

Step 2. The mouthpiece, teaser needle, and inhaler-pipette bowl are medical grade.

Step 3. Sanitize the crown, teaser needle, and inhaler-pipette’s mouthpiece and administering bowl with an isopropyl alcohol (70% or higher) pad.

MONITOR DOSING SCHEDULE AND EFFECTS

Inhale one microdose at a time with the MDI-P, and wait a minimum of 15 minutes between doses.

Maintain a journal of your symptoms, the strain used, number of doses, effectiveness of each dose, and duration of effects for each dose.

We recommend using the Tetragram medical cannabis journaling app on your smartphone for an easy way to track your sessions, identify what works best for you, and optimize your treatment. Scan the QR code to download the app.